Dr. Munir Silwadi


Dr.-Munir-Silwadi

A B.D.S Graduate in 1975, Dr. Silwadi maintained a general dentistry private practice in Abu Dhabi, UAE as well as in Toronto, Canada. Since 2000, as an M.Sc. specialist prosthodontist, he is running a multi speciality dental center and is limitinghis practice to the fields of prosthodontics, Implantology, and CAD/CAM esthetic dentistry.

Opinion leader in the Prosthodontic field for the last eight years. His academic achievements as member of the Royal College of Dental Surgeons of Ontario Canada, Certificate of the Dental Examining Board of Canada, ISCD Certified International Trainer keep his name as a well-known consultant in CAD/CAM.

Chairside Indirect Veneers, Inlays, and Onlays: A – to – Z
09:00 – 18:00

Almost 30 years ago, the first Chairside Indirect Ceramic Restorations were introduced; a posterior tooth Bonded Ceramic Inlay was digitally imaged, designed, and manufactured using CEREC Chairside CAD/CAM equipment.
Through the years since then, CEREC has enjoyed huge development and improvements to enhance the accuracy of the final result. The capabilities of the system were as well developed to manufacture Veneers, Crowns, as well as Inlays and Onlays i.e. Partial Crowns. Nowadays, the system is capable to digitally produce almost every type of single tooth restorations as well as bridges both on natural teeth and implants.

This workshop will offer hands on demonstration on models created out of actual cases. Participants will be able to use the full capabilities of the system to practice all steps required to produce and bond Veneers and Partial Crowns, especially to restore endodontically treated teeth.

Learning objectives:
At the end of this workshop, participants should be able to:
Realize steps required to produce Chairside CAD/CAM restorations.
Compare the steps needed to produce Laboratory Generated Indirect Restorations to Indirect Chairside Restorations.
Enhance their knowledge required to produce indirect CAD/CAM Restorations.

Workshop Layout:

09:00 – 10:00 Introduction to CEREC System Hardware / Software
10:00 – 11:15 Demonstration /Practice Partial Crown on Standard Model
11:15 – 11:30 Coffee Break
11:30 – 12:45 Demonstration /Practice Veneer on Standard Model
12:45 – 13:30 Lunch
13:30 – 15:30 Demonstration /Practice Partial Crown on Actual Case Model including bonding and chairside polishing
15:30 – 17:30 Demonstration /Practice Veneer on Actual Case Model including bonding and chairside polishing
17:30 – 18:00 Discussion / Distribution on Certificates.